ASRock H61M-GS XFast RAM Driver
File name: File size: MB Version: latest Downloads. ASRock H61M-DGS BIOS Recenzija: Supports ASRock XFast RAM, XFast LAN, XFast USB Technologies Supports AXTU, Graphical UEFI, Instant Boot, Instant Flash, APP Charger, SmartView.
|Supported systems:||Windows XP, Windows Vista, Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit, Windows 10, Windows 10 64 bit|
|Price:||Free* [*Free Registration Required]|
ASRock H61M-GS XFast RAM Driver
ASRock H61M-GS XFast RAM not force to insert the CPU into the socket if above situation is found. Otherwise, the CPU will be seriously damaged. Disengaging the lever by depressing down and out on the hook to clear retention tab.
ASRock P65iCafe LGA - Материнские платы во Владивостоке
Rotate the load lever to fully open position at approximately degrees. Rotate the load plate to fully open position at approximately degrees. It is recommended to use the cap tab to handle and avoid kicking off the PnP cap. This cap must be placed if returning the motherboard for after service. Insert the ASRock H61M-GS XFast RAM CPU: Hold the CPU by the edge where is marked with black line.
Locate Pin1 and the two orientation key notches. Carefully place the CPU into the socket by using a purely vertical motion. Verify that ASRock H61M-GS XFast RAM CPU is within the socket and properly mated to the orient keys. Rotate the load plate onto the IHS.
While pressing down lightly on load plate, engage the load lever. Before you installed the heatsink, you need to spray thermal interface material between the CPU and the heatsink to improve heat dissipation.
Ensure that the CPU and the heatsink are securely fastened and in good contact with each other. For proper installation, please kindly refer to the instruction manuals of your CPU fan and heatsink. Below is an example to illustrate the installation of the heatsink for Pin CPU. Apply thermal interface material onto center of IHS on the socket surface.
Apply Thermal Interface Material Step 2. Place the heatsink onto the socket.
Align fasteners with the motherboard throughholes. Rotate the fastener clockwise, then press down on fastener caps with thumb to install and lock. Repeat with remaining fasteners.
Fan cables on side closest to MB header Fastener slots pointing straight out Press Down 4 Places If you press down the fasteners without rotating them clockwise, the heatsink cannot be secured on the motherboard. Connect fan header with the CPU fan connector on the motherboard.
H2 Shop webshop - računala, komponente, mrežna oprema, tableti. ASRock
Secure excess cable with tie-wrap to ensure cable does not interfere with fan operation or contact other components. Please be noticed that this motherboard supports Combo Cooler Option C. Otherwise, it will operate at single channel mode. If you install only one memory module or two non-identical memory modules, ASRock H61M-GS XFast RAM is unable to activate the Dual Channel Memory Technology.
It is not recommended to install them on this motherboard. Unlock a DIMM slot by pressing the retaining clips outward. Installing an expansion card Step 1.
Before installing the expansion card, please make sure that the power supply is switched off or the ASRock H61M-GS XFast RAM cord is unplugged. Please read the documentation of the expansion card and make necessary hardware settings for the card before you start the installation. Remove the system unit cover if your motherboard is already installed in a chassis.
ASROCK H61M-GS M-ATX Inventum Øst Gjøvik
Remove the bracket facing the slot that you intend to use. Keep the screws for later use. Align the card connector with the slot and press irmly until the card is completely seated on the slot. Fasten the ASRock H61M-GS XFast RAM to the chassis with screws.